Power flush Lutterworth | Powerflushing in Leicestershire.

Think you could need a powerflush in Lutterworth? Our teams high quality powerflushing services are perfect for you if you have noticed issues that could include clunking pipes and noises similar to a boiling kettle, as well as cold spots on your radiators, it’s possible that the water in your heating system has accumulated sludge, rust, scale and other debris.

Looking to book your appointment ?

This lowers boiler efficiency and increases your heating bills. A quality powerflush aims to remove these deposits and the problems that they cause. If your radiators are cold at the top, it means that there is air in the system and needs bleeding, cold at the bottom or middle means sludge (magnetite) and needs cleaning/removing.

 

Chemical powerflushing services in Lutterworth allows heating systems to be cleansed using water at high velocity, but low pressure, so that no physical damage is caused to the system. The process can be made even more effective with the addition of powerful cleansing and mobilising agents. The objective is to restore your heating system to optimum operation.

 

Professional powerflushing, in conjunction with our magnetic system is also an excellent way to pre-commission clean new heating systems, to remove excess flux, swarf and other debris, the grease and oil used to prevent rusting of components before use.

 

It is also prudent to power flush a heating system immediately before fitting a new boiler to an existing system to prevent possible future problems. Many systems are found to contain corrosion and sludge, even if no flow problems have yet shown themselves.

Our Powerflushing engineers in Lutterworth will:

 

  • Isolate the cold feed to your central heating system

  • Remove the lowest positioned radiator and connect a professional power flushing pump and magnet system to flow and return pipework

  • Set up the power flush system, connect to your mains water and connect the dump valve

  • Open all radiators, taking care to check the operation of the valves and start the power flushing process

  • Power flush using the magnetic system, concentrating on each individual radiator, pipe and valve, plus your pump, boiler and  boiler heat exchanger

  • Add the chemicals and agitator tool to dissolve sludge, hardened deposits, scale and silt and use a special tool on each radiator to loosen any stubborn sludge

  • Check that the condition of the radiator water and the pH level (measure of acidity) is similar to your mains drinking water level, then add an inhibitor to help prevent future build-up of sludge, scale, corrosion and bacteria

  • Run your central heating and balance the system to ensure the distribution of heat is correct

  • Check the output of your boiler using a flue gas analyser and take a reading of output efficiency

  • Provide all of the above for one fixed price

  •  

The prices below include all labour and all chemicals required:

 

Up to 6 radiators      £280.00 + VAT

7 to 8 radiators         £300.00 + VAT

9 radiators                £320.00 + VAT

10 radiators              £340.00 + VAT

11 radiators               £360.00 + VAT

ADDITIONAL RADIATORS AT £20.00 + VAT

 

If you would like more information or a quote for a Power Flush in Lutterworth, then Contact Us today  where a member of our friendly team will gladly assist you.

24hr emergency call

out service

Call today: 

01908 990593

Services 

Areas Covered 

Lutterworth,

Leicestershire

Rugby,

Warwickshire, Northamptonshire, 

Buckinghamshire

More 

Contact

Master Contractors Ltd

11 Chapel Lane,

Walcote,

Leicestershire,

LE17 4JS

 

Further Information

Facebook

Google+

Twitter

Privacy Policy

Terms & Conditions

Site Map

T: 01455 550154

M:07480 312966

E: info@Mpcontractors.com

W: www.mpcontractors.com

 © 2014 - 2020 Master  Contractors Ltd - Registered office: 11 Chapel Lane, Walcott, Leicestershire, LE17 4JS